NukaTap Mini – Wall Mount Shank Kit (duotight 6.35 mm)

This shank kit is specifically designed for Nukatap Mini taps and allows you to connect the Nukatap Mini to a cooler box, a kegerator, a keg fridge, a cold‑room wall or any other flat surface.

The new design routes the beer line directly to the back of the tap, greatly reducing the volume of non‑refrigerated beer.

In addition, its system uses three screws that lock the tap in a fixed position and prevent it from rotating. By loosening the 1/2" stainless collar, you can still orient the tap as you wish, but once tightened, the interlocking teeth of the shank and the Nukatap Mini keep the tap perfectly aligned.

Easy installation:

Unlike other long shanks, this kit does not require a 22 mm hole saw to drill through the wall. Since no through‑shank is needed, only a hole large enough for the beer line is required. A simple 8 mm drill bit is therefore sufficient, making installation much easier.

Compatible with all wall thicknesses:

If your wall is less than 80 mm thick, you can use the supplied screws, which feature snap‑off points allowing you to shorten them easily.

If the wall is thicker than 80 mm, simply purchase a standard screw from a hardware store to secure the kit. If the substrate is firm enough, you may not even need to drill all the way through the wall: a 30 mm screw may be enough.

Technical specifications:

• - Beer line diameter: compatible with any EVABarrier line with 6.35 mm OD, such as 3 mm x 6.35 mm (1/4") double‑wall EVA
• - Collar and screw cover: 304 stainless steel
• - O‑rings: silicone/EPDM combination
• - Plastic support: POK
• - Temperature range: from -10°C to 100°C
• - Maximum pressure: 150 psi

The NukaTap Mini is sold separately.