3-spout countertop beer dispenser with ice bank

3-spout countertop beer dispenser with ice bank

The 3-spout ice-bank beer filler is a countertop model that uses a water-cooling system to keep beer at the right temperature. It features three stainless steel coils for serving three kegs of beer. It is sold with service taps and requires connection to a CO2 cylinder. It has a power rating of 381W and a dispensing capacity of 95 liters per hour.

As the machine is not supplied with fittings, the filler's inlet diameter is divided into 3 5/8" male ports. For the best possible fit, we recommend that you purchase 3 John Guest flat-bottom female union fittings. Several versions of this product are available. To make sure you get it right: the BSP you choose should always be 5/8". For the tube, this will depend on the size of the pipes in your line (often 5/16" or 3/8"). If you don't have any pipes, then we recommend John Guest pipes (5/16" or 3/8", the choice is yours). We also advise you to mark these hoses (CO2 lines and beer lines) so as not to confuse them.

To use this beer filler, follow the steps below:

• Connect the filler to an electrical outlet and fill the water tank to the indicated level.
• Connect the beer kegs to the filler inlets (as mentioned above, we recommend 5/8" BSP flat-bottom female union fittings to 3/8" or 5/16" tube, depending on the diameter of your line pipes).
• Connect the CO2 bottle to the filler outlet, adjusting the pressure according to the type of beer. (It is also possible to connect the CO2 to your beer kegs).
• Open the service taps and let the water run through the system until you see the beer coming (this will prevent the water from freezing in the pipes and making your service impossible).
• Leave the filler to cool for about 30 minutes, until the green light comes on.
• Serve the beer by holding the glass at an angle under the tap and gradually raising it.

Technical spec. :

• 3x Coils (8/7 x 14 + 12 + 10)
• Ice bank cooling
• 220/240 Volt 50 Hz
• Stainless steel
• Sold with service taps
• inlet diameter 5/8" male
• Power : 381W 1360 kj/h 1HP
• Dimensions : 520x315x425
• Weight : 45 Kg
• Dispensing capacity : 95 litres/hour