Visy chuck for CDLE/CDL can ends (Ardagh Group) for Cannular

Chuck/bell for CDLE‑standard ends.

Replacement part for the Cannular can seamer.

Specifications:

• - Made from hardened stainless steel
• - Machined to a 20‑micron tolerance
• - Fits a 19 mm drive shaft
• - Tightened using a 3 mm Allen key

No need to change the rolls: simply replace the chuck, make fine adjustments to the rolls and table height, and you will be able to seam CDLE ends in no time.

Most aluminium can bodies are manufactured according to the same standards, including the 202 standard.

CDLE ends explained:

CDLE ends are the main type sold by VISY, which licenses this technology from Ardagh Group.

Some people use the term CDL loosely, but the correct technical name for this specific end type is CDLE, not to be confused with its predecessor CDL+.

*To install the chuck, refer to the document available in the “downloads” tab.