Warming Wizard Wand 2' TC Element 500watt @ 220-240V / 125watt @110-120v

The Warming Wizard Wand is a high‑performance immersion heater designed for demanding brewers. Unlike external heating belts, this element is fully submerged in the wort (via a compatible fermenter wall port), ensuring immediate heat transfer and extremely stable temperature control, even in cold environments.

Why choose this product?

• Maximum thermal efficiency: Direct contact with the liquid allows for faster and more even heating compared to external contact systems.
• Sanitary design: Made from food‑grade 304 stainless steel, it is easy to clean and poses no risk of altering your beer.
• Standardized installation: Thanks to its 2" Tri‑Clamp format, it mounts in seconds on most modern conical fermenters.

Technical specifications

• Power: 500W at 220–240V (or 125W at 110–120V).
• Total probe length: approx. 300 mm.
• Heating element material: 304 stainless steel.
• Flange type: 2" Tri‑Clamp (64 mm flange diameter).
• Wiring: Integrated power cable with EU plug.
• Protective housing: Insulating resin around the connector.
• Not included: 2" Tri‑Clamp clamp, 2" gasket, temperature controller (RAPT or Inkbird type).

Rolling Beers Tips

• Mandatory control: Never plug in the heater unless it is fully submerged in liquid, as the element may burn out instantly.
• Automation: Pair this tool with a temperature controller (Inkbird ITC‑308) to automate heating whenever your wort drops below the setpoint.
• Maintenance: After each use, clean the probe with a PBW‑type solution to prevent organic buildup (krausen or proteins) that could burn during the next use.
• Safety: Always use this equipment with a grounded outlet protected by a residual‑current circuit breaker.

Product FAQ

Can I use it to boil my wort?
No. At 500W, this heater is designed for temperature maintenance or gentle heating. It is not powerful enough to sustain a vigorous boil for 20L or more.

Is it compatible with FermZilla fermenters?
It is compatible with any fermenter equipped with a 2" Tri-Clamp port. If your FermZilla has a 2" outlet, it can be installed. However, for safety reasons, we recommend using this heating element only on the lower area of stainless steel fermenters.

Can the element caramelize the wort?
Thanks to its distributed power density, the risk of caramelization is very low during fermentation (small temperature increases). However, it is not recommended for use in highly concentrated, undiluted sugar solutions.