IceMaster G60 Glycol Chiller with Digital Control 220-240V

Icebank/Glycol Chiller G60

Piping made of 304 stainless steel, 8 mm, with welded ½-inch male threads, allowing compatibility with a wide range of hose fittings.

With a height of 890 mm, this unit is quite large and does not fit under most counters, so it is recommended to plan a custom setup or place it next to the counter.

It is important to note that with a single pass, the G60 can only reduce your product's temperature by 15°C. Therefore, we strongly recommend chilling your kegs before the event (and keeping them cold if possible), especially if you are serving in an environment where the temperature exceeds 30°C.

Recommended Setup

The inlet and outlet connections of the G60 are ½-inch male BSP threads.

Our 6mm x 9mm PVC tubing is generally the correct diameter for beer lines.

To set up a chilled font, you will also need heavy-duty silicone and clamps.

Specifications

• Product lines: 6 stainless steel lines
• Product line size: 304 stainless steel coils (½-inch BSP thread, 7mm ID)
• Cooling output line: 10mm OD, 8mm ID

Capacities

• Tank capacity: 70L water
• Cooling capacity: 780 watts (1HP) (rated at 22°C)
• Typical product cooling capacity: 90 liters in the first hour, 35 liters each additional hour
• Compressor wattage: 450 watts
• Refrigerant: R600A

Dimensions

• Width: 530 mm
• Depth: 530 mm
• Height: 890 mm

Digital Temperature Controller

Simply set your upper and lower limits with the controller.