Stainless steel trigger filler

Description

Summary

Discover this stainless steel trigger filler with a simple but ingenious design.
This filler is ideal for bottling your beer from a soda keg or a pre-sure fermenter.

Thanks to the CO2 pre-filling system, you can purge your bottles before filling them with your beer, itself pushed with CO2. This stainless steel trigger filler allows you to minimize the risk of oxidation of your beers, especially your IPA.

The detail

• Stainless steel
• Ergonomic and easy to use trigger
• Intuitive CO2 purge washer
• Stem to fill all sizes of bottles
• 5x8mm vinyl food hose
• Hose holder
• Hose clamp

The use of the stainless steel trigger filler is very simple. The supplied hose will be used to connect the CO2 line to the hose holder B.

Please note: you will need a double outlet CO2 regulator for this. If you do not have one, you will not be able to purge your cylinders.

Trigger C will be used to send the beer into your bottles. Just before you do this, you can purge your bottles by pressing the washer D.
The hose clamp E is optional, it will be used if the hose F is too wide for your ball lock connectors.

Attention: in order to avoid an abundant production of foam during your transfer, it is recommended to do it at 3°C, after cold crash and/or a good cold forced carbonation.

In order to connect the liquid inlet to the outlet A, you must provide a 3/8" John Guest hose not supplied with a suitable clamp.

Due to its design, this filler may require the addition of Teflon to ensure a good seal of the fittings after use