Premium Counterflow Cooler Kit

  • Reference: pack_refroidisseur1

Counterflow cooler with magnetic pump.
Connections and pipes for must circulation included.


The countercurrent cooling system allows the circulation of the wort in one direction and the circulation of water in the other direction, without contact between the two.
The cooling speed is therefore greatly accelerated!

This pack offers :

  • a countercurrent cooler with a total length of 9.5m, allowing to cool 20L of wort in 5min under optimal conditions.
    The cooler is equipped with Gardena fittings for water circulation and tuayu door for wort circulation.


  • a magnetic booster pump, able to withstand high temperatures up to 100°C and to circulate the wort as soon as it has finished boiling.


  • the necessary fittings and pipes for the circulation of the wort.

Easy to use, this system will allow you to cool your wort whatever your brewing tank.

Pack content

The best compromise to quickly cool your brew.
In a counter-current cooler, the hot wort flows in the opposite direction to the cooling water, allowing for optimal heat exchange.
With such a cooler, your wort is cooled faster while reducing the necessary water consumption.

Built of AISI 304 stainless steel, this counter-current cooler is not exposed to rust and can easily be cleaned by the circulation of a detergent and then a disinfectant.

Total length: 9.5m
Fittings for wort: diameter 13mm
Fittings for water: gardena type
Weight: 4kg

High-quality magnetic pump for pumping liquids up to 100°C. The pump has a high-quality stainless steel inlet and outlet and is equipped with an on/off switch.

  • clear liquids up to 100°C
  • 1/2" stainless steel fittings
  • 8 - 12 litres per minute
  • 10 W - 240 V
  • on/off switch
  • fully enclosed housing
  • virtually silent
  • up to 1.5 metres head
  • not self-priming
  • Attention: do not run the pump dry
  • 3-year warranty


  • circulation during mashing process when combined with filter bottom
  • transfer of wort from lauter tun to brewing kettle
  • transfer of wort from brewing kettle to fermentation tank (connection behind the cooler)
  • re-circulation of cleaning solution through plate chiller, soda keg, etc.
  • circulation of cooling water for water-cooled fermentation tanks

Complete set for using your Brewferm Booster magnetic drive pump to circulate wort, cleaning products etc.

The set includes:

  • 2 m silicon hose (9 x 13 mm); which can be cut to size depending on your set-up.
  • 2 1/2" hose socket 13 mm; fits perfectly with the accompanying silicone hose.
  • large plastic hose clip for clamping the output of your pump. This allows users to reduce the output flow rate if desired. Applicable when you are using your Booster as a circulation pump for wort.

Warning: only clamp the output end of the pump. Clamping the input end may cause the pump to run dry, which can lead to overheating.

Resistant to high AND low temperatures:

  • -50°C to +260°C.
  • Does not release any odour or taste.
  • Price per metre
  • Ø 9 x 13 mm.

Data sheet


Stainless Steel clip binding for clamping tubes onto tube holders. Simply tighten with a screw driver.

In the same category

3 other products seleted for you


No customer reviews for the moment.